1. Remove the carabiner hook and ring from the end of the cable.
2. Remove the screw, washers, spring and metal button.
3. Loosen the two screws and remove the lid of the balancer.
4. Remove the housing and unwind the cable.
5. Unscrew the four screws, remove the lid and pull the cable out a little.
6. Cut the cable and pull it out of the housing.
7. Use a piece of tape to attach the new cable to the old one.
8. Pull both cables through the Elephants Trunk, so the new cable is inserted. Remove the tape and old cable.
9. Remove the stopping ball from the old cable by loosening two screws.
10. Remove the thimble by cutting the old cable.
11. Place the thimble on the end of the new cable that is at the top end of the Elephants Trunk by using a cable ferrule.
12. Clamp the cable ferrule tightly in two places.
13. Attach the stopping ball to the new cable approx. 25 cm from the thimple, using the two screws.
14. Pull the other end of the new cable through the housing and attach a cable ferrule. Clamp it tightly in two places and pull the cable ferrule into the housing.
15. Place the lid back on the housing, make sure the edge on the housing falls into the recess in the lid.
16. Tighten the four screws.
17. Place the balancer lid and metal button back on the housing.
18. Pull the new cable through the Elephants Trunk while placing back the balancer.
19. Tighten the two screws of the balancer.
20. Wind up the new cable by turning the metal button counterclockwise.
21. Turn the metal button an additional one or two turns when the cable is wound. Do not turn the button more than two times!
22. Place the screw, washers and springs back into the metal button and tighten the screw.
23. Attach the ring and carabiner to the thimble of the new cable.

Also watch our instruction video.